|
|
Airfoil Radio
Isotope
The Radio Isotope Hood features a stainless
steel lining and work surface with coved corners
that facilitate thorough cleaning and a reinforced
countertop to support lead bricks. These features
will help to insure operator safety and convenience
in procedures that involve the use and handling of
radioactive materials. The Radio Isotope Hood comes
equipped with a type 304 stainless steel sash frame
with a full width flush pull. The interior lining
is also type 304 stainless steel. All seams are welded
and ground smooth to eliminate the build-up of radioactive
materials. The work surface, which is constructed
of the same materials, is welded to the lining, making
the liner and work surface integral and water tight.
In addition, the work surface is reinforced to support
200 lbs. per square foot up to a total weight of
1,000 lbs. per Hood or base cabinet section.
- Full view sash has laminated safety glass, full
width flush pull, and counterweight for one finger
operation.
- Inward angled frame minimizes turbulence resulting
in a more efficient operation.
- Double wall construction of the hood superstructure
allows for easy installation of service fixtures
and routing of interior plumbing and electrical
lines.
- Removable exterior side panels and removable
panels on both interior sides allow easy access
to service fixtures and supply lines.
- A maximum width, two tube fluorescent light fixture
is mounted above a sealed safety glass panel.
|
- Service fixtures
- Water
- Explosion proof light
- Sinks
- Electrical outlets
- Air velocity monitors and alarms
- Horizontal sliding
sashes
- Sash stops
- Custom sizes
- Pre-plumbing and wiring
|
|
|
|
|
|
|
|